Flashing on one end of builds

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
samatheang
Solus Expert
Posts:197
Joined:Wed Feb 17, 2016 10:36 pm
Re: Flashing on one end of builds

Postby samatheang » Mon May 09, 2016 7:30 am

Thanks, Mark. Will do.
User avatar
M-Williams
Solus Master
Posts:393
Joined:Sun Nov 01, 2015 4:45 pm

Re: Flashing on one end of builds

Postby M-Williams » Tue May 10, 2016 12:43 am

Most likely it is either The graphic card or some messed up setting. Please check your display settings first.... What system are you running.
samatheang
Solus Expert
Posts:197
Joined:Wed Feb 17, 2016 10:36 pm

Re: Flashing on one end of builds

Postby samatheang » Tue May 10, 2016 1:46 am

@M-Williams I think so too. I am using a laptop with Nvidia Geforce G 105M. I used a Full RGB toggle utility because there is no option to set it in the Nvidia Control Panel. For the projector, I am using Vivitek DH913. Just ordered a new laptop with Intel Graphic HD 5500. Will try it again when it arrives.
Jubiler
Novice
Posts:19
Joined:Tue Oct 20, 2015 4:09 am

Re: Flashing on one end of builds

Postby Jubiler » Tue May 10, 2016 3:23 pm

Turn off manualy windows defender even when you turn off updates, Internet windows defender still works.
I have similar issue.
User avatar
M-Williams
Solus Master
Posts:393
Joined:Sun Nov 01, 2015 4:45 pm

Re: Flashing on one end of builds

Postby M-Williams » Wed May 11, 2016 1:07 am

It would be cleaver if you dedicate a laptop just to the printer . Do all your initial settings and than turn it off the World . for file I use transfer use a memory stick.

Who is online

Users browsing this forum: No registered users and 5 guests