Print failure
Hello Everyone! Any suggestions why this prints fail out?
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Print failure
Pawel,
Try rotating your rings 90 degrees along the Z asix then printing. The flex in the shank can cause that if you don't support the inside of the ring properly. Orienting it with ring finger hole along the X axis instead, lessens the flex forces.
Try rotating your rings 90 degrees along the Z asix then printing. The flex in the shank can cause that if you don't support the inside of the ring properly. Orienting it with ring finger hole along the X axis instead, lessens the flex forces.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 16 guests