I just installed the solus and i get only print failures.
Can please somebody help me.
print failure
Re: print failure
Hi,
You need to make sure your graphics is set to full RGB. Please read this section in the manual.
You need to make sure your graphics is set to full RGB. Please read this section in the manual.
Re: print failure
Many thanks for your help
All configuration is according to the manual.
And also it prints smaller than the archive.
All configuration is according to the manual.
And also it prints smaller than the archive.
Re: print failure
Refresh rate it was 59p Hz in the manual was 60p Hz.
You thing that maybe the problem.
You thing that maybe the problem.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: print failure
You clearly haven't enabled Full RGB. Notice how the entire build area is cured. That's the background light curing the resin over time because the full rgb is not enabled.
Please go over the instructions again step by step. Every step is important.
Please go over the instructions again step by step. Every step is important.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: print failure
As said above. Make sure you are in the correct graphics settings for the displays. Re read instructions. Depending on the computer and operating system it can be confusing to find the correct display setting area.
Re: print failure
Helo all
Im looking for manual or instractions how to configure creation workshop with solus
somebody can help me.
Thanks
Im looking for manual or instractions how to configure creation workshop with solus
somebody can help me.
Thanks
Re: print failure
I'll email you the links now.
Re: print failure
Again print fairures.
Now my prints braking at the left side
Now my prints braking at the left side
Who is online
Users browsing this forum: No registered users and 87 guests