failed prints
-
- Novice
- Posts:33
- Joined:Fri Dec 11, 2015 5:03 am
I've been having this problem, I start a print and it feels like I'm taking a 50/50 chance that it will print or not. my last two prints have been done twice, and they still don't come out. I have changed the film, recalibrated the build plate. and made sure my supports are big enough. even put new resin, not recycled. this is just like wow, need to get it going. any ideas. when it prints good great. but lately need help.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: failed prints
Seems like you have large cross sections on that ring. It's better to slightly tilt it to make the slices smaller.
If you want me to show you how to support it, please email me the file.
If you want me to show you how to support it, please email me the file.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 17 guests