Printer controls locked up.

[TJLuxe]

My printer controls are locking up after I do a $h command. It won't let me jog up after it goes to home position. All the controls just lock up and I have to restart the computer and do $x command to get it to let me move the arm up and then when I do $h again it locks up. Been trying to get it to work all weekend so any help is appreciated. Thank you.

[mongerdesigns]

Hi Travis,

When the arm moves down all the way, do you get OK OK in the command window readout?

If not, try pulling up on the quartz window from the left side twice. Once you get the OK commands, you should be able to move up the platform.

If you need more help contact info@junction3d.com

[TJLuxe]

That worked for the arm to move up but when I $h again it does the same thing. I did tried to do prints and the keep failing. I don't think the tilt is working on the quartz table, I can usually hear it when its printing and I dont.

[mongerdesigns]

Contact support at info@junction3d.com and we'll help you.