Projector changes distortion

[Chrisno]

I managed to find out the correct settings to put my grid straight, but unfortunately the distortion changes. So I have to find new settings each time I start to print. This is bad enough, but it seems the distortion changes even during the print job which causes curvy vertical lines. Has anyone ever had this problem? I do not find any posts concerning this topic. Is this issue caused by the computer or by the Beamer(vivitec)
Any suggestions are welcome.

[reify]

Hi,

I haven't seen this bug. Which version of Contour are you running? Which version of Windows?

[Chrisno]

I use windows10 and contour beta 1.1.7

[mongerdesigns]

Update to the latest version, then go to edit/preferences, choose your projector, press ok. That should fix the issue and save the settings.

[Chrisno]

....done. I will update you with the results.

[Chrisno]

........this did not solve the problem. Grid distortiortion did change during the last print job. So what else can I try?

[mongerdesigns]

when you change the values and exit the software. When you go back, did the values change to something else?

email me at info@junction3d.com and I can connect to your pc remotely and see if I can fix this for you.

[Chrisno]

The values did not change but the grid changed. So I will have to entre new values. I will contact you tomorrow for help.

[mongerdesigns]

If that's the case, then it could be computer graphics card related. Are you using an HDMI cable or VGA?

[Chrisno]

I use HDMI cable