problems with setting

[podivo]

Monger Designs a.k.a. Monger
Solus R&D, Resin R&D, Support, CAD and 3d printing expert
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Top

Previous PMNext PMMove to folder: Inbox 

Expand viewMessage history:

Re: hardware problems

Sent: Mon Sep 21, 2015 1:15 am
by podivo

mongerdesigns wrote:Hi Pavol,

You can recalibrate the build plate. Loosen the 4 hex screws. Put a piece of paper on the top glass. Home with the build plate on. Push down on the build plate and make sure all the corners are touching. Then slowly tighten the screws. That's it.



Hi,
It is two weeks  what  I am testing printer.
I have everything  setting under manual ,but  every print goes to failure.
I do not know why happen things like this:
for example: When I push slick button projector start to project pictures.
sometimes slice is stick only on film ,but not on built plate.
Often happens that print is doing well ,but projector will stop project with some reason....after few minutes.



Pavol  

[mongerdesigns]

Pavol,

It seems to me like a computer issue. Mark tried to contact you to help you figure it out. Did you get his email?