HI
This thin layer sometimes fall into resin tank..even it will damage the surface of platform when cleaning..
i tried already changing the settings Exposure 80x45 - All 2.1 bottom 5
any tips?
Thin layer on built platform
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Re: Thin layer on built platform
Any photos? Might need more support in that area.
Re: Thin layer on built platform
check
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Re: Thin layer on built platform
this full platform
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Re: Thin layer on built platform
You over expose the initial layer
Re: Thin layer on built platform
what i have to do?
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Re: Thin layer on built platform
You have to reduce the time of your "Initial Layer Exposure", this time depend on your projector power. For my Vivitek it's around 3s but you can put more to be sure it will stay on the build plate.
Re: Thin layer on built platform
I HAVE Vivitek 1188 Can you share me some settings ? pls
Im always printing trough 80x45 mm platform
Im always printing trough 80x45 mm platform
Last edited by CHAMAL on Mon Apr 03, 2017 3:05 pm, edited 1 time in total.
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Who is online
Users browsing this forum: No registered users and 92 guests