HOMING PROCESS STUCK PLATFORM ARM NOT GOING UP

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Post Reply
User avatar
CHAMAL
Novice
Posts:52
Joined:Fri Mar 31, 2017 12:45 pm
Location:srilanka
Contact:
Contact CHAMAL
HOMING PROCESS STUCK PLATFORM ARM NOT GOING UP

Postby CHAMAL » Mon Apr 03, 2017 3:25 am

HI MY PRINTER WAS STUCK ONCE HOMING PROCESS IT DOESN'T GO UP. WHAT I HAVE TO DO?
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Top
User avatar
CHAMAL
Novice
Posts:52
Joined:Fri Mar 31, 2017 12:45 pm
Location:srilanka
Contact:
Contact CHAMAL

Re: HOMING PROCESS STUCK PLATFORM ARM NOT GOING UP

Postby CHAMAL » Mon Apr 03, 2017 3:32 am

FIXED- TIP REMOVE ALL THE WIRES AND RE PLUGGED AND SWITCH ON.ONCE AGAIN DO THE PRINT WIZARD.
I WAS WONDERING IF PRINTER HAVE LED INDICATOR FOR POWER.
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Top
User avatar
Archerm
Solus Master
Posts:599
Joined:Mon Oct 26, 2015 1:57 pm
Location:North Carolina

Re: HOMING PROCESS STUCK PLATFORM ARM NOT GOING UP

Postby Archerm » Wed Apr 05, 2017 8:28 pm

No led for power just the switch on the back.
Top
Post Reply

Return to “Help and Troubleshooting”

Who is online

Users browsing this forum: No registered users and 93 guests