grainy missing parts and heavy build lines
in the past a scuffed film would cause these grainy missing parts, any other suggestions on a cause? also these heavy build lines at 75% of the build seems to be showing up, any thoughts?
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: grainy missing parts and heavy build lines
Do you happen to know if your film is too tight.
Re: grainy missing parts and heavy build lines
hey Mark, thats always a challenge to figure that out. i always tighten the screws until it just feel resistance. whats crazy is every print for months was perfect i didnt even need to think about anything then it all went to shit. im back up to ok with green only but i really like the quality i was getting with a 50%50% b9 green and cherry. in a perfect world 50/50 b9 green/ maker juice was the best resolution but could cast it. it pitted everywhere. we are gonna try the premere optima investment from stuller to see if that makes a difference,
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: grainy missing parts and heavy build lines
Might be your tilt motor then. I suggest getting the new tilt motor upgrade kit. Contact me for details if interested.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 5 guests