New Computer, no success

[Cassio]

Hey all

So I've just been having a hard time trying to figure out why my new computer isn't getting success.



I've tried loosening the tension on the vat film, switching usb ports for the printer, re-calibrating...

I think that the issue may be that the InFocus isn't projecting black, but dark dark grey. I've been in the graphics properties and can't seem to figure out how to change anything that may help.


Below is all I've been able to grow, about 4 different times.

Any help would be greatly appreciated, thanks.

[mongerdesigns]

Did you set the Quantinization Range to FULL in the intel options, just like it shows in the instructions?

If you don't see that option in there, you may need to update your intel graphics drivers.

[Cassio]

Did you set the Quantinization Range to FULL in the intel options, just like it shows in the instructions?

If you don't see that option in there, you may need to update your intel graphics drivers.

So I've just downloaded the drivers that the Intel Driver Update Utility recommended. There still isn't a Quantinization Range there. What should I do next?

[Messerbr]

When you're in the Intel Graphics options make sure to select the projector instead of the laptop monitor in the drop down menu. The option to select Full RGB will be in the 'Advanced' tab

[Cassio]

When you're in the Intel Graphics options make sure to select the projector instead of the laptop monitor in the drop down menu. The option to select Full RGB will be in the 'Advanced' tab

Yep found it! Had to restart the computer a few times but it's showing up now. Thanks. Lets hope this works now.