Mis prints

[mongerdesigns]

Residue or resin on the bottom of the tank or on the Quartz is big no no (because: optical surface)

[Jewelermdt]

So what can I use to get it off the quartz. I tried a little dawn on damp pec pad. Followed by alcohol l. Still a little film/residue.

Also would this be why it printed the whole gird?

[mongerdesigns]

Definetly not dawn. I use 90% alcohol from the drug store and a paper towel on the Quartz. For the bottom of the tank use pec pads with some alcohol instead of paper towels. Paper towels will scratch the film.

[mongerdesigns]

If it printed the entire build area then you need to check your graphics card settings as described in part 1 of the manual.

[Jewelermdt]

Will check to see if my settings got changed somehow.
After getting to top of the table clean I notice the underside also had a film on it along with the mirror. Had some resin seep inside and guessing the fumes cause the residue. All clean now.

[Archerm]

Have you checked these out in Netfab?

[Jewelermdt]

Yes it went through netfab.

[Jewelermdt]

Did a print today and it came out great. That is after I fixed my settings for the display adapter. Thanks for suggesting Emil. Figured it was going to be computer related.
I swear a ghost lives in Windows 10. Not only where mys settings changed, but Cortana switched back on. I have tried to disable all extra junk running.

[Archerm]

Its amazing what is always running on a computer. I have tried to remove as much stuff as I can o0n my laptop for the Solus. The more junk I remove the more consistent the prints are. What is worse the newer laptops have all the App crap and it is loaded with blotware. I think I finally have most of that removed as well. Mark

Did a print today and it came out great. That is after I fixed my settings for the display adapter. Thanks for suggesting Emil. Figured it was going to be computer related.
I swear a ghost lives in Windows 10. Not only where mys settings changed, but Cortana switched back on. I have tried to disable all extra junk running.

[Jewelermdt]

Instead of making a new post I post here. Was printing a pendant today and look at printer and the platform was all the way up. So figured it was done. Soon as I walked back there it went down in a hurry. Thought I was going to have a broken quartz. I notice it was at 107% complete. I swear I have gremlins in my computer.

[img]

107percent.JPG

[/img]