Bad calibration
-
- Novice
- Posts:12
- Joined:Fri Jul 01, 2016 9:55 am
hello. today i calibrate again the printer for 25xy fallowing the instruction . after the printing done the shapes was very distorted. can someone help me with few tips for a better calibration .
Re: Bad calibration
Hi,
Please double check your projector and graphics card setting settings. There is a lot of extra cured resin around the bases of the cubes that shouldn't be there.
What kind of graphics are you running?
Please double check your projector and graphics card setting settings. There is a lot of extra cured resin around the bases of the cubes that shouldn't be there.
What kind of graphics are you running?
-
- Novice
- Posts:12
- Joined:Fri Jul 01, 2016 9:55 am
Re: Bad calibration
i use nvidia gtx 980m as graphic card
Re: Bad calibration
That should be fine. Just make sure it's on full RGB and all the settings on the projector menus are correct. Sometimes if you unplug the projector or change computers they can revert to default. Are you running Contour?
-
- Novice
- Posts:12
- Joined:Fri Jul 01, 2016 9:55 am
Re: Bad calibration
yes i use Solus contour . i use vivitek 1188 can you share some settings for projector?
Re: Bad calibration
Hi,
All the settings are in the manual. I'll email you the latest version.
All the settings are in the manual. I'll email you the latest version.
-
- Novice
- Posts:12
- Joined:Fri Jul 01, 2016 9:55 am
Re: Bad calibration
Hello. I have some error to sett scale adjustment!
Down you have link to video with screen of my PC!
I need to understand, why I have this error and how I can to resolve this problem.
Thanks
https://www.youtube.com/watch?v=Ye4jhviYcNg
Down you have link to video with screen of my PC!
I need to understand, why I have this error and how I can to resolve this problem.
Thanks
https://www.youtube.com/watch?v=Ye4jhviYcNg
Re: Bad calibration
Hi,
I'm sorry but your video doesn't seem to be working.
I'm sorry but your video doesn't seem to be working.
-
- Novice
- Posts:12
- Joined:Fri Jul 01, 2016 9:55 am
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Bad calibration
You keep going back into the scaling adjustment mode. Once you press Ok. You need to close the setup window.
Also once you adjust the scaling you need to re-load your scene.
Also once you adjust the scaling you need to re-load your scene.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 93 guests