Page 1 of 1
Bad calibration
Posted: Tue Aug 01, 2017 8:07 am
by diamantelor
hello. today i calibrate again the printer for 25xy fallowing the instruction . after the printing done the shapes was very distorted. can someone help me with few tips for a better calibration .
Re: Bad calibration
Posted: Tue Aug 01, 2017 8:13 am
by reify
Hi,
Please double check your projector and graphics card setting settings. There is a lot of extra cured resin around the bases of the cubes that shouldn't be there.
What kind of graphics are you running?
Re: Bad calibration
Posted: Tue Aug 01, 2017 8:17 am
by diamantelor
i use nvidia gtx 980m as graphic card
Re: Bad calibration
Posted: Tue Aug 01, 2017 8:22 am
by reify
That should be fine. Just make sure it's on full RGB and all the settings on the projector menus are correct. Sometimes if you unplug the projector or change computers they can revert to default. Are you running Contour?
Re: Bad calibration
Posted: Tue Aug 01, 2017 8:50 am
by diamantelor
yes i use Solus contour . i use vivitek 1188 can you share some settings for projector?
Re: Bad calibration
Posted: Tue Aug 01, 2017 9:33 am
by reify
Hi,
All the settings are in the manual. I'll email you the latest version.
Re: Bad calibration
Posted: Wed Jan 31, 2018 12:58 pm
by diamantelor
Hello. I have some error to sett scale adjustment!
Down you have link to video with screen of my PC!
I need to understand, why I have this error and how I can to resolve this problem.
Thankshttps://www.youtube.com/watch?v=Ye4jhviYcNg
Re: Bad calibration
Posted: Wed Jan 31, 2018 2:53 pm
by reify
Hi,
I'm sorry but your video doesn't seem to be working.
Re: Bad calibration
Posted: Wed Jan 31, 2018 3:03 pm
by diamantelor
Re: Bad calibration
Posted: Wed Jan 31, 2018 4:53 pm
by mongerdesigns
You keep going back into the scaling adjustment mode. Once you press Ok. You need to close the setup window.
Also once you adjust the scaling you need to re-load your scene.