This is my first print..... please help!!!
First Printout Fail. Please help.
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: FIRST PRINTOUT FAIL! PLEASE HELP!!!
Did you check you graphic card settings. We can not tell from the pictures if it is a support issue.
Re: FIRST PRINTOUT FAIL! PLEASE HELP!!!
I would do that piece in multiple parts.
Re: FIRST PRINTOUT FAIL! PLEASE HELP!!!
Hi,
Hard to see what happened from the photos but it looks like a support issue. I'll email you a test ring to try first.
Hard to see what happened from the photos but it looks like a support issue. I'll email you a test ring to try first.
Re: First Printout Fail. Please help.
support issue same mark said,look to thin support.
Re: First Printout Fail. Please help.
Now I tried to print the file. This the result. But I'm not sure about the size.
Re: First Printout Fail. Please help.
Thank you guys.
I found that the support of the model is the big issue here. Now this is my latest print. Looks better except the bottom surface but still figure out.
I found that the support of the model is the big issue here. Now this is my latest print. Looks better except the bottom surface but still figure out.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: First Printout Fail. Please help.
Angle it and then print.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: First Printout Fail. Please help.
mongerdesigns wrote:Angle it and then print.
When you say "Angle", is it about rotating the object before print?
Who is online
Users browsing this forum: No registered users and 31 guests