Hello Fellow Solus Users,
I've been wanting to post up a image of a common problem I've been having and I hope one of you maybe have some advice. Finnally I have a larger piece where it shows my issue. It is common in most of my rings but hard to photograph which makes it hard to show you guys.
I highlighted in the photo were you'll see I wanted to make a perfect circle, but get a sagging or stretching near the bottom main support. This is in the new SolusCast but I've also experience this in Emerald Green as well. I don't thinks its the resin but possibly my supports. Although I have in the past added extra supports and wider main supports and I might see slightly better results, but still never a perfect curve to the bottom.
Any tips or suggestions would be greatly appreciated.
Looking for advice on small issue
Best Regards,
Luke Johnson
Senior Designer
Arthur's Jewelers Creations.
Other Custom Designs by Luke Johnson
Luke Johnson
Senior Designer
Arthur's Jewelers Creations.
Other Custom Designs by Luke Johnson
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Looking for advice on small issue
Need to support more of the bottom curvature. Make a wider bottom support or use the ring support in Contour.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 91 guests