Ring print bigger size

General topics about 3d printing.
dcpattni
Novice
Posts: 92
Joined: Sat May 07, 2016 4:55 pm
Location: Dar-es-salaam,TANZANIA
Contact:

Ring print bigger size

Postby dcpattni » Thu Dec 27, 2018 10:13 am

Hello Everyone,

I had problem with printing 2 ring long time when i managed @30z ring size is bigger.....cad guy also recheck all fine.....printed 4 times same ring... I and cad guy have not add sinkage....i can share same ring SC file....anyone have idea why?

below i have attached screenshot for calibration sample full platform but i have noticed preview and grid on screen match..printer grid and printer paper grid matches....is it correct?..many times if i print full platform its different sizes center,conner etc.


regards,
DIpen
Attachments
IMG-20181226-WA0065.jpg
IMG_20181226_213256.jpg
IMG_20181226_213443.jpg
solus preview.JPG
solus grid.JPG
User avatar
mongerdesigns
Solus Guru
Posts: 1854
Joined: Sat Apr 25, 2015 5:16 pm
Location: Los Angeles
Contact:

Re: Ring print bigger size

Postby mongerdesigns » Thu Dec 27, 2018 6:22 pm

You're doing it wrong. Reset your grid. Don't adjust the size of the grid through software. That module is only for adjusting the spherical distortion. You need to adjust the size of the grid using the physical zoom dial on the projector.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
dcpattni
Novice
Posts: 92
Joined: Sat May 07, 2016 4:55 pm
Location: Dar-es-salaam,TANZANIA
Contact:

Re: Ring print bigger size

Postby dcpattni » Fri Jan 04, 2019 7:36 pm

Anyone got such problem before.
I have elephant pose in right view i did mirror in 3D builder to left view then both file open in SC....after i save SC file and reopen SC file dimension change it self....below screenshot.....first time i did print like this i didn't no..after cleaning and casting found why 0.4-0.6mm difference.

but if i don't save file n put support then print it looks ok on SC dimension but after cutting the supports i see its little bit change dimension both don't match same size.

also noticed after i scaling to 150% open STL file it will automatically do scaling which ever last was checked it will go on that scaling.

hope you understand what i'm trying to say.

regards,
dipen
Attachments
100 scaling right view.JPG
155 scaling left.JPG
scaling 155 right.JPG

Who is online

Users browsing this forum: No registered users and 3 guests