so Iv been having real good results casting the soluscast by just curring in my Quans 20 w lamp overnight and treeing up and casting in optima invesment , been happy with my results ,
But this question is for suggestions and ideas as to how people are removing the rings ( soluscast ) from the build plate , I find I'm making a mess every time I do , I'm using a plastic watch tool ( Bergon ) I got from jules borel , worked fine for the green but the blue really sticks a lot harder to to the plate and am having a bear of a time ?
can some one share what they are using with some pics please
removal of rings from build plate ??
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: removal of rings from build plate ??
I use one of these to remove the prints very carefully. Sometimes, just a regular blade without the holder so I can get it laying flat enough and gently separate the part without damage.
https://www.amazon.com/Ehdis-Stainless- ... B01HNGSWAS
https://www.amazon.com/Ehdis-Stainless- ... B01HNGSWAS
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: removal of rings from build plate ??
I use a single edge razor blade. What monger uses without the handle
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: removal of rings from build plate ??
I use the same. Just lay the blade as flat as possible to the platform. I use a wiggle motion.
Re: removal of rings from build plate ??
I use a chirurgical scalpel works fine
Re: removal of rings from build plate ??
I put a drops of Denature alcohol where the plate and base layers meet and then pull up a little.
Once a little pulls up I then put another drop of denature alcohol and from then on it just peels very easily without snaping.
It works very well
Just don't put Denature Alcohol on the model.
Once a little pulls up I then put another drop of denature alcohol and from then on it just peels very easily without snaping.
It works very well
Just don't put Denature Alcohol on the model.
Re: removal of rings from build plate ??
Scalpel here as well.
Who is online
Users browsing this forum: No registered users and 11 guests