Reify3D Forum

so Iv been having real good results casting the soluscast by just curring in my Quans 20 w lamp overnight and treeing up and casting in optima invesment , been happy with my results ,

But this question is for suggestions and ideas as to how people are removing the rings ( soluscast ) from the build plate , I find I'm making a mess every time I do , I'm using a plastic watch tool ( Bergon ) I got from jules borel , worked fine for the green but the blue really sticks a lot harder to to the plate and am having a bear of a time ?

can some one share what they are using with some pics please

I use one of these to remove the prints very carefully. Sometimes, just a regular blade without the holder so I can get it laying flat enough and gently separate the part without damage.

https://www.amazon.com/Ehdis-Stainless- ... B01HNGSWAS

I use a single edge razor blade. What monger uses without the handle

I use the same. Just lay the blade as flat as possible to the platform. I use a wiggle motion.

I use a chirurgical scalpel works fine

I put a drops of Denature alcohol where the plate and base layers meet and then pull up a little.
Once a little pulls up I then put another drop of denature alcohol and from then on it just peels very easily without snaping.
It works very well

Just don't put Denature Alcohol on the model.

Scalpel here as well.