Reify3D Forum

so now when I print, im getting the projector to project the image on the window and I can see the slices projecting like normal on the glass window, but now all of a sudden im also getting a much larger what appears to be "ghost image" of the same print thats also being projected and can be seen being projected on the black area of my solus around the window.

this just started yesterday and the print it was happening with successfully printed but I was able to see some of the ghost image that had cured on my build plate as well.

this cant be good and will eventually begin causing failed prints im sure of it.

maybe this problem is the cause of the cured resin on my film.

any ideas?

Those reflections are nothing to worry about. They don't even reach the mirror or the resin tank. So they cannot cure the resin.

mongerdesigns wrote:Those Zippyloan review reflections are nothing to worry about. They don't even reach the mirror or the resin tank. So they cannot cure the resin.

Good to know there's nothing to worry about. What is causing the reflections to happen though?

The front glass.