Can anyone can help me with this please,
I looked everywhere for a answer , my bottom and right side calibration lines dont show, also how can i get the distortion/bend out of the calibration display?
TJ-
Bottom and right side calibration lines dont show
Re: Bottom and right side calibration lines dont show
Hi,
Please watch the video "Calibrating the Build Area"
http://reify-3d.com/forum/viewtopic.php?f=12&t=104
If you're still having trouble, please contact Emil.
Please watch the video "Calibrating the Build Area"
http://reify-3d.com/forum/viewtopic.php?f=12&t=104
If you're still having trouble, please contact Emil.
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Bottom and right side calibration lines dont show
Your table top must be real flat and level. Check your position of the projector, feet screwed all the way in. You might have to shim it a little or twist the printer a little. My cabinet top is plywood, it's very slightly bumpy but enough to throw things out of wack. Also my lens drops down with the weight of the close up lens. I built a clip to pull it back up so the gird is more in center of table. My lines were also off the edge on the right side but just a little adjusting got things lined up.
-
- Novice
- Posts:50
- Joined:Mon Apr 25, 2016 3:49 pm
Re: Bottom and right side calibration lines dont show
My problem is when I level the bubble that's on the machine the level of the liquid is really shifted. So I ignored the bubble and leveled the liquid while the vat is on the machine, will this work? Also I took out the screw that's in the middle of the projector and swung it around to get the full grid on the platform, would this be ok?
Who is online
Users browsing this forum: No registered users and 71 guests