Bottom and right side calibration lines dont show

[tjsnyman]

Can anyone can help me with this please,
I looked everywhere for a answer , my bottom and right side calibration lines dont show, also how can i get the distortion/bend out of the calibration display?
TJ-

[reify]

Hi,

Please watch the video "Calibrating the Build Area"

http://reify-3d.com/forum/viewtopic.php?f=12&t=104

If you're still having trouble, please contact Emil.

[Jewelermdt]

Your table top must be real flat and level. Check your position of the projector, feet screwed all the way in. You might have to shim it a little or twist the printer a little. My cabinet top is plywood, it's very slightly bumpy but enough to throw things out of wack. Also my lens drops down with the weight of the close up lens. I built a clip to pull it back up so the gird is more in center of table. My lines were also off the edge on the right side but just a little adjusting got things lined up.

[joeyalbano]

My problem is when I level the bubble that's on the machine the level of the liquid is really shifted. So I ignored the bubble and leveled the liquid while the vat is on the machine, will this work? Also I took out the screw that's in the middle of the projector and swung it around to get the full grid on the platform, would this be ok?