I don't get it. You are using the emerald settings to print using the yellow resin? It won't work.
The instructions on how to install the yellow resin profile is clearly shown here viewtopic.php?f=8&t=125
Also, you shouldn't use the CW supports. I see you're using matrix 8 for some of the supports? You should use it for the rest of them.
Some of the orientation on you pendants is wrong, creating too many overhangs, especially on the prongs.
Some of the rings have a base, some don't.
Since you are still getting used to your machine and learning, i suggest printing one thing at a time, so it's easier to troubleshoot your issues.
Partial prints?
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Partial prints?
I saw the post, but link was not so visible, I must have over looked it. We'll give that a shot.
Re: Partial prints?
That worked great! I even did all of them at 25z. They looked great!! Very pleased with the detail.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Partial prints?
Glad that worked out! Yes, the yellow profile is different. I had to modify the peel cycle for it because that resin is very sticky.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 82 guests