Failed Prints

[jdwages]

Just would like to hear some thoughts. I have been printing a large Gents ring, 1st time prints perfect then the next 2 times it fails. Any ideas on why this happens I think I am doing the same thing each time? It is a large ring and can only fit 1 at a time @ 48x27 build area.

[nillard]

I like to wipe the vat coating to make sure nothing is stuck.. Maybe something is stuck?

[jdwages]

I check it between prints, vat is clean and almost new film. #4 is on now and failing.

[mongerdesigns]

I would try printing at the 42xy. It will give you a larger build area so it's not pushed into the borders like that.

Where does it fail? Any specific spot?

[jdwages]

I will give that a try. Latest try stopped print after I saw it was failing.

[rcdesign]

Sometimes I'll run a large detailed piece fine then subsequent grows fail. Netfabb indicates errors. Just a thought.

[mongerdesigns]

I see some flashing around the bases. Large areas.

Have you checked your full rgb settings?

[jdwages]

I thought I had but double checked and made the change to full. Thanks Emil

[jdwages]

I changed the RGB to full and still getting the flashing on my base. I did get the model to print successfully 2 times in a row. Thanks

[mongerdesigns]

A little flashing can be ok, but you can control it by lowering your base exposure a bit.

Glad it's working for you now.