Failed Prints
Just would like to hear some thoughts. I have been printing a large Gents ring, 1st time prints perfect then the next 2 times it fails. Any ideas on why this happens I think I am doing the same thing each time? It is a large ring and can only fit 1 at a time @ 48x27 build area.
Re: Failed Prints
I like to wipe the vat coating to make sure nothing is stuck.. Maybe something is stuck?
Re: Failed Prints
I check it between prints, vat is clean and almost new film. #4 is on now and failing.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Failed Prints
I would try printing at the 42xy. It will give you a larger build area so it's not pushed into the borders like that.
Where does it fail? Any specific spot?
Where does it fail? Any specific spot?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Failed Prints
I will give that a try. Latest try stopped print after I saw it was failing.
Re: Failed Prints
Sometimes I'll run a large detailed piece fine then subsequent grows fail. Netfabb indicates errors. Just a thought.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Failed Prints
I see some flashing around the bases. Large areas.
Have you checked your full rgb settings?
Have you checked your full rgb settings?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Failed Prints
I thought I had but double checked and made the change to full. Thanks Emil
Re: Failed Prints
I changed the RGB to full and still getting the flashing on my base. I did get the model to print successfully 2 times in a row. Thanks
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Failed Prints
A little flashing can be ok, but you can control it by lowering your base exposure a bit.
Glad it's working for you now.
Glad it's working for you now.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 100 guests