Good Evening all;
I am kinda ocd about some things. I run alot at night after I get done at work, and set up a print and my alarm top get up and pull off the prints after completed. I have noticed that the prints are running long, almost 20 % long, a 2 hour 20 minute print, runs almost 2 hours 45 to 50 minutes. Am i doing something wrong, or iit just the way printing is, and the timer is an estimate?
Todd
Printing Times
- toddmichael
- Novice
- Posts:77
- Joined:Sun Jul 05, 2015 4:33 am
- Location:Motor City, Mi
Toddmichael
Firestorm Cad / Jeweler / Designer
Firestorm Cad / Jeweler / Designer
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Printing Times
Sometimes depending on the computers speed the software can miscalculate the time. You're not doing anything wrong.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 9 guests