Cure Crazy
Cure your prints in a clear glass or bowl of water. You will be amazed. Oxygen inhibits curing.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Cure Crazy
Warm or hot water has even less oxygen. So might cure faster. However, make sure the alcohol has dissipated from the prints for about 30 min or so, or else you will get a white residue on your prints if you cure in water.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Cure Crazy
if I clean my prints in my ultrasonic with dish soap after I rinse in alcohol will I still need to let them sit or will they be fine to go into water to cure? Also is it just plain tap water?
Who is online
Users browsing this forum: No registered users and 83 guests