Page 1 of 1
Molding Solus Proto Resin
Posted: Thu Dec 22, 2016 5:51 pm
by goldfish2
Has anyone tried to Hot Rubber Mold the Proto Resin? If so would you mind sharing which rubber worked well? I found some info on someone molding the Emerald Resin from B9 some time back with Cataldo Pink but can't seem to find that info any where.
Re: Molding Solus Proto Resin
Posted: Fri Dec 23, 2016 9:27 pm
by DAHolland
Do you mean vulcanisation- I am very interested to know if the resin will stand up to this
Re: Molding Solus Proto Resin
Posted: Sat Dec 24, 2016 3:00 am
by Jewelermdt
There are several silicone rubber that vulcanize at a low temp. Like under 190 degrees. These should work just fine since lots of people heat treat at 250 degrees.
Re: Molding Solus Proto Resin
Posted: Sun Dec 25, 2016 7:51 pm
by miniman
We use it fr vulcanized molds. Workd outstanding.
Re: Molding Solus Proto Resin
Posted: Sun Dec 25, 2016 8:44 pm
by Archerm
Castaldo no shrunk pink here. Works great.