What happen went no print in the plate?
How Know the weight for resine to gold or silver thanks for the support.
Last edited by MDLEON on Fri Mar 17, 2017 3:10 am, edited 1 time in total.
Re: What happen went no print in the plate?
Did you go through the setup and go through the full RGB setup? Did you remove the filter on the projector? What resin are you using?
Re: What happen went no print in the plate?
Hi,
May I ask where you are located?
As Archerm asked, did you remove the UV filter?
May I ask where you are located?
As Archerm asked, did you remove the UV filter?
Re: What happen went no print in the plate?
Thanks for your reply, I used B9 yellow, everything come half and no come!
Re: What happen went no print in the plate?
Yes I remove the uv from inside the first time to set up.
Re: What happen went no print in the plate?
We are I found the RGB I have windows 10, thanks for your support.
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: What happen went no print in the plate?
Just follow the basic initial steps. don't try to rush your calibration process. you will be printing high end prints in on time.
Re: What happen went no print in the plate?
I had a couple that didn't show up on grow plate. The plate needs to be sanded up so it's no soo smooth so the resin does no stick. And you printed something but no print on plate check you resin tank bottom for start plate the is on bottom then nothing on future will how in that area because curing light is being blocked.
Re: What happen went no print in the plate?
It appears your question has changed. Unless you know the specific gravity of the resin in question, I generically use a s.g. of 1.1 in my calculations to normalize it, then use the s.g. for the metal in question to get your metal weight.
Who is online
Users browsing this forum: No registered users and 9 guests