Hi,
As I'm going to print my first test print, I found no movement in z motor when I try to run home cycle. Please help me to sort out this problem.
Thanks,
Regard,
Kamal Soni
Home cycle not running
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Home cycle not running
Did you turn the power on from the back?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Home cycle not running
mongerdesigns wrote:Did you turn the power on from the back?
Yes, I turn on power from the back.
Re: Home cycle not running
Make sure that you restart the Contour software when you start a new print.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Home cycle not running
It's not required to restart the software before each print.
Did you install the Arduino drivers per the instructions?
If yes, please contact the person you purchased from and they can login and check your computer.
Did you install the Arduino drivers per the instructions?
If yes, please contact the person you purchased from and they can login and check your computer.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Home cycle not running
I meant to say turn off the count our and restart it if you turn the projector or printer off and back on. My computer with countour software won't recognize the printer or projector if I don't turn them on first before I pull up the software.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Home cycle not running
Archerm wrote:I meant to say turn off the count our and restart it if you turn the projector or printer off and back on. My computer with countour software won't recognize the printer or projector if I don't turn them on first before I pull up the software.
If it won't recognize it, all you need to do is go to File, Setup, Connect to controller. But yes, restarting Contour does the same.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 112 guests