I want to switch to 42xy but when I projecting grid, from top grid projecting outside the build area, please help me to bring projection down to the center of the build area.
Regard,
Kamal
How to center the Grid
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: How to center the Grid
Is your projector properly mounted. Did you have the PDF instructions?
Re: How to center the Grid
M-Williams wrote:Is your projector properly mounted. Did you have the PDF instructions?
yes, I have the PDF instructions and followed all the instructions.
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: How to center the Grid
Make sure the feet are screwed in all the way, especially the front one. The surface for your printer setup is very flat. Make sure the plate is not bent up to much. It will lift the printer up in the front and cause that. You may have to shim the printer a tad to get it lined up. Follow instruction in the Video section on adjusting the grid.
Re: How to center the Grid
Hi,
Which projector are you using? The 1186, 1188 and Optoma have a vertical lens shift wheel above the zoom wheel.
For 42XY, the grid should be closer to the back of the quartz (but inside the boundaries obviously) and at 25XY the projection will be closer to the front.
Which projector are you using? The 1186, 1188 and Optoma have a vertical lens shift wheel above the zoom wheel.
For 42XY, the grid should be closer to the back of the quartz (but inside the boundaries obviously) and at 25XY the projection will be closer to the front.
Re: How to center the Grid
reify wrote:Hi,
Which projector are you using? The 1186, 1188 and Optoma have a vertical lens shift wheel above the zoom wheel.
For 42XY, the grid should be closer to the back of the quartz (but inside the boundaries obviously) and at 25XY the projection will be closer to the front.
Viviteck H-1185HD
Re: How to center the Grid
Still waiting for your response
Re: How to center the Grid
Hi,
Use the feet to raise the back of the projector until the grid is within the frame. If necessary, then use the keystone (buttons on the top of the projector or remote) to straighten the sides of the grid.
Use the feet to raise the back of the projector until the grid is within the frame. If necessary, then use the keystone (buttons on the top of the projector or remote) to straighten the sides of the grid.
Re: How to center the Grid
reify wrote:Hi,
Use the feet to raise the back of the projector until the grid is within the frame. If necessary, then use the keystone (buttons on the top of the projector or remote) to straighten the sides of the grid.
When I raise the back of the projector, mount become free from two magnetic screw. Can I loose these two screw?
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: How to center the Grid
put a shim under the plate to raise it up and catch the alignment feet.
Who is online
Users browsing this forum: No registered users and 5 guests