3d pen
What do you think of this 3d pen to fix a print that got damaged when removing supports like a prong or chip? https://youtu.be/bJxEqAax55Q
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: 3d pen
I know a few have used them. You can get one from Loews or Home Depot.
Re: 3d pen
You can buy a UV flashlight from Amazon to do the same thing.
Re: 3d pen
rkundla wrote:You can buy a UV flashlight from Amazon to do the same thing.
I have the flash light but its not good to build prongs, the resin starts to go everywhere
Re: 3d pen
Ah, I see, you wanted to rebuild features that broke off.
Hmm... I wonder if that pen would work with a resin like B9 Emerald? In the video (I only skimmed it) the pen looked like it dispensed a thick resin.
Hmm... I wonder if that pen would work with a resin like B9 Emerald? In the video (I only skimmed it) the pen looked like it dispensed a thick resin.
Re: 3d pen
rkundla wrote:Ah, I see, you wanted to rebuild features that broke off.
Hmm... I wonder if that pen would work with a resin like B9 Emerald? In the video (I only skimmed it) the pen looked like it dispensed a thick resin.
At first i will try to cast with there resin, as all resin can be casted if there isn't a big chunk, if not i will try with b9's
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: 3d pen
Take a section of the supports that printed. cure it. cut it and use a little resin to glue it to prong broken off. Then use the pen to cure it.
Re: 3d pen
I use that 5second fix pen that you can buy at many stores it has a thick consistency so it won't run all over but stay where you need it and hit with built in uv light for a fry seconds and just sand to blend in.
Re: 3d pen
Gtg330 wrote:I use that 5second fix pen that you can buy at many stores it has a thick consistency so it won't run all over but stay where you need it and hit with built in uv light for a fry seconds and just sand to blend in.IMG_0511.JPG
Great i will get one
Who is online
Users browsing this forum: No registered users and 4 guests