I wouldn't use 0.1mm or 0.2mm for those prongs at the top of the ring when printing the top part upside down. At the beginning of the print when the build plate is dipped in the Vat, you need very strong supports since there is more separation force during that time. I would use something closer to the size of the prong like 0.4mm, and don't use Sphere Touch Points. Good luck.
dcpattni wrote:hi,
after suggestion from SOlUS users experts i try as below:-
1st try single ring white 0.1mm support which print good easy to removed supports but bottom(dome area) prongs it was not perfect.
2nd try in 2 parts as Mr.Sam advice, it worked very clear but top front only it did not print well....but rest was clean & clear images below.
3rd try with 0.2mm only for Dome it didn't grow....
All suports are manualy.
I always mix b9 very very well before filling in VAT.
what do you think........i m doing few other printing going OK....only this ring mirco prongs giving tuff time.