Page 3 of 3

Re: Stuck on home cycle, motors won't turn

Posted: Sun May 13, 2018 2:23 am
by Jewelermdt
Kris
If I'm getting great prints I will not remove my vat and home with it on. I do not tighten my vat that much. Iv'e never had a problem. BUT never home with the platform on.

Re: Stuck on home cycle, motors won't turn

Posted: Thu Jun 21, 2018 12:35 pm
by hx19035
This is a dumb question perhaps....but should we all upgrade the tilt motor just in case? Better yet, how can I tell I have the old tilt motor?
My printer is working fine though. Probably shouldn't mess with it. LOL

Re: Stuck on home cycle, motors won't turn

Posted: Thu Jun 21, 2018 1:37 pm
by mongerdesigns
If you look into the printer from the top window, towards the left tilt side, you can see the motor. If the motor screw has a plastic tip then it’s the old motor. The new motor is all metal.