Platform not level

Topics about Solus 3d Printer's hardware
User avatar
toddmichael
Novice
Posts:77
Joined:Sun Jul 05, 2015 4:33 am
Location:Motor City, Mi
Re: Platform not level

Postby toddmichael » Wed Sep 23, 2015 7:39 pm

Awesome, I have a bangle to print by the end of the week if possible?

Toddmichael
Toddmichael
Firestorm Cad / Jeweler / Designer
User avatar
Jewelermdt
Solus Master
Posts:809
Joined:Sun Jul 19, 2015 10:38 pm
Location:N.W. Florida
Contact:

Re: Platform not level

Postby Jewelermdt » Thu Sep 24, 2015 1:57 am

Is it Todd or Michael?

I have had multi problems that I am just now figuring out. Supports for my models is the biggest thing. Plus I found that my cabinet top is a little bumpy and causing my projector to tilt the picture. So when I put down a piece of paper to measure the grid for calibration, (before showing the gird on the printer) I did not see that the lines went over the edge of the quartz table. So my calibration was a little off. Just when I think I got everything worked out, I accidentally hit the fast Z down in stead of up and broke my table. Now waiting till I get the parts.
User avatar
hx19035
Novice
Posts:91
Joined:Thu Feb 18, 2016 5:48 pm
Location:USA
Contact:

Re: Platform not level

Postby hx19035 » Fri Apr 01, 2016 11:54 pm

Jewelermdt wrote:Got the answer from Monger posted it on 3Dcad forum.



What's the solution to this just in case it happens to any of us too.

Thanks!
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: Platform not level

Postby mongerdesigns » Fri Apr 01, 2016 11:56 pm

A video that shows how to calibrate the build plate is in the videos section here viewtopic.php?f=12&t=104
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/

Who is online

Users browsing this forum: No registered users and 5 guests