Reify3D Forum

Awesome, I have a bangle to print by the end of the week if possible?

Toddmichael

Is it Todd or Michael?

I have had multi problems that I am just now figuring out. Supports for my models is the biggest thing. Plus I found that my cabinet top is a little bumpy and causing my projector to tilt the picture. So when I put down a piece of paper to measure the grid for calibration, (before showing the gird on the printer) I did not see that the lines went over the edge of the quartz table. So my calibration was a little off. Just when I think I got everything worked out, I accidentally hit the fast Z down in stead of up and broke my table. Now waiting till I get the parts.

Jewelermdt wrote:Got the answer from Monger posted it on 3Dcad forum.

What's the solution to this just in case it happens to any of us too.

Thanks!

A video that shows how to calibrate the build plate is in the videos section here viewtopic.php?f=12&t=104