projector not projecting?
-
- Solus Expert
- Posts:136
- Joined:Thu Feb 25, 2016 4:09 pm
i have been printing very well every day for the past 2 weeks and now, after doing three prints, I try to send a new file to the printer and the printer goes through the motions of printing, except the projector will not project...when I close out creation workshop the projector projects my desktop and whatever I have open just fine but it no longer seems to be projecting my prints,i can even get my slice view in creation workshop to project but it wont project during printing process?? what gives?
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: projector not projecting?
What gives is probably your display is set incorrectly in cw. Make sure the actual projector display number is what's under configured displays.
Contour software makes all this much much easier with automatic device port detection and setup.
Contour software makes all this much much easier with automatic device port detection and setup.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 10 guests