[SOLVED] Z - Zero Motor Stop Error
Posted: Tue Dec 20, 2016 6:31 am
Hi All,
Solus has been printing solid AOK for some time now getting perfect results. Last prints produced build table returning back to it usual finish location.
Tried to get some prints going today and Solus goes down to Zero Z but doesnt stop - hits the zero location and keeps wanting to go down. I have tried both Creation Workshop and Solus Contour same problem. Any possible clue on why the motor would be behaving like this after last print no problem.
Here is crash report.
https://drive.google.com/folderview?id= ... sp=sharing
thanks for any advice.
Solus has been printing solid AOK for some time now getting perfect results. Last prints produced build table returning back to it usual finish location.
Tried to get some prints going today and Solus goes down to Zero Z but doesnt stop - hits the zero location and keeps wanting to go down. I have tried both Creation Workshop and Solus Contour same problem. Any possible clue on why the motor would be behaving like this after last print no problem.
Here is crash report.
https://drive.google.com/folderview?id= ... sp=sharing
thanks for any advice.