[SOLVED] Solus will not perform homing cycle
Tried to print tonight and the solus would not perform the homing cycle. I cancelled the print and went to the set up. I clicked connect to printer and that seemed to work but when I click homing cycle I get nothing.??
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Solus will not perform homing cycle
Are you running CW or Contour. Can you run Z up and down? Is the Z drive movable when powered off? Try different usb port.
Re: Solus will not perform homing cycle
I'll email you now to debug the issue.
Re: [SOLVED] Solus will not perform homing cycle
How was this solved? I had this problem suddenly appear right after i updated my ver 1.4 to 1.6. After hours of troubleshooting I downgraded back to 1.4. Still didn't work, left to get something to eat and came back and was suddenly working
Yep, I tried in CW also; I could only get it to home after re-plugging the usb cable. After that, couldn't do anything.
Yep, I tried in CW also; I could only get it to home after re-plugging the usb cable. After that, couldn't do anything.
Who is online
Users browsing this forum: No registered users and 6 guests