I had a power outage and the crystal stopped in the down position. The software wont move it back. how do I manually adjust it? Thanks!
BTW... How do you add photos here?
crystal platform is stuck in the from a power outage
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: crystal platform is stuck in the from a power outage
You need to close Contour, unplug the USB cable from the back of the machine, and plug it back in. Then start the software and run the home cycle. It should move the glass back up.
You post pictures by clicking on the Attachements tab, uploading the file and then clicking on Place Inline.
You post pictures by clicking on the Attachements tab, uploading the file and then clicking on Place Inline.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 5 guests