Print Failures since Contour 1.4 upgrade
-
- Solus Expert
- Posts:197
- Joined:Wed Feb 17, 2016 10:36 pm
You have to connect it to a source like your laptop to be able to adjust brightness, contrast, etc.
Re: Print Failures since Contour 1.4 upgrade
Okay my bad, I didn't have the computer turned on. Everything checks out okay then on the settings.
Re: Print Failures since Contour 1.4 upgrade
i set the projector back up with the Solus. All projector settings are correct, RGB Full and still showing dim light on project black and when print starts.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Print Failures since Contour 1.4 upgrade
The dim light is normal. It will never just project pure black. We just don't want bright light when it's not projecting anything.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Print Failures since Contour 1.4 upgrade
Okay, I'll try another actual grow tomorrow, Thanks Emil
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Print Failures since Contour 1.4 upgrade
Please clean the glass and the lenses with a lens cleaner pad, or some alcohol and microfiber cloth. Just to make sure you don't have any residue on there that can scatter light.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 1 guest