Reify3D Forum

I must hand it to the Solus team. The newest version 1.9 is really nice. I and I am sure others really appreciate all the effort. There are definitely some great additions to this version. Thanks guys........................... Mark II

Thank you Mark! Glad you like it. We have lots more cool features planned, just need the time to make it happen.

hey guys, is there a changelog anywhere?

also, is there a way to force a support tip to a place that with the given angle the software does not want to put any?

ty

We don't have a detailed change log. viewtopic.php?f=4&t=793

No, you cannot force to put a support tip on a surface that is pointing upwards, because that would be counter effective.

1.9 Is the best. Simplifies calibration. My prints are even better now. Emil, yall are doing a fantastic job.

Thanks Len! Glad you like it.

Thank you for optimizing the settings and improving the software! I like the changes!
Is the 'light intensity' setting on the SolusCast profile for weaker bulbs/adjusting exposure?
I don't remember seeing it before.

Yes, the Light Intensity is for optimizing the setting for bulb of various age. For example if you have an older bulb, you might want to increase it. If you see that you're getting some Z bleed then you might want to decrease it.

SolusCast prints using blue light, and putting this setting on 5 will print with white light.

Hello Emil,

I just downloaded 1.9
Is there any chance of getting a bottom view as discussed here viewtopic.php?f=4&t=983&p=7965#p7965
I was really looking forward to that addition

mongerdesigns wrote:Yes, the Light Intensity is for optimizing the setting for bulb of various age. For example if you have an older bulb, you might want to increase it. If you see that you're getting some Z bleed then you might want to decrease it.

SolusCast prints using blue light, and putting this setting on 5 will print with white light.

Hi

The light intensity, does it effect you scale dimension?