Contour Feature Idea about failed print

jisaac
Novice
Posts:55
Joined:Fri Jun 10, 2016 10:47 am
Contour Feature Idea about failed print

Postby jisaac » Thu Mar 01, 2018 7:48 pm

Hello,

Today back to my workshop 2h after launching my 3d print, no cured resin stuk in the platform.
So I had this idea of a checkbox "Move up the platform during the first minutes" in order to check the print is starting well.
It's so frustrated to find out the print has failed since the begining.

Jacques
eangor
Novice
Posts:20
Joined:Thu Oct 05, 2017 6:42 pm

Re: Contour Feature Idea about failed print

Postby eangor » Thu Mar 01, 2018 11:48 pm

You can do that by clicking the Pause button during print.
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: Contour Feature Idea about failed print

Postby mongerdesigns » Fri Mar 02, 2018 12:27 am

Yes. Just press the pause button and then resume button to continue printing.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
jisaac
Novice
Posts:55
Joined:Fri Jun 10, 2016 10:47 am

Re: Contour Feature Idea about failed print

Postby jisaac » Fri Mar 02, 2018 6:20 am

Thank you for this trick.
I hope this failed print was from a film issue.

Who is online

Users browsing this forum: No registered users and 5 guests