Failure to home
Posted: Sat May 12, 2018 6:00 pm
I've seen several posts on this same topic, hoping for some extra help. I stopped a failed print in mid-stream, clean my vat and reloaded the print, unfortunately my printer would not home. I did a search on homing and read several possible solutions and followed them.
I did un-plug the USB, turned off the printer and pressed the rest button. I then reloaded the program and tried to re-home the printer, but it is stuck in the upper position and now working.
Are their any other solutions to getting the machine to home?
Thank you for any advice,
Joseph
I did un-plug the USB, turned off the printer and pressed the rest button. I then reloaded the program and tried to re-home the printer, but it is stuck in the upper position and now working.
Are their any other solutions to getting the machine to home?
Thank you for any advice,
Joseph