Scale adjustment
Posted: Tue May 22, 2018 2:04 am
I just replaced my tilt motor and I'm noticing that the z-axis height seems to be floating a bit. I printed three 10x10x10 test blocks and entered the information into the scale adjustment calculator. The z height seems to be going back and forth. The first time I printed it the z height was 9.63mm the second time it was 10.38 and the third time it went back to 9.63mm. I'm entering the measurement and hitting apply. I have marked the top of the cube with X and Y to keep my alignment correct. Any suggestions on what could be going on? I did just replace my tilt motor.
BTW...i notice when I make the Z-axis scale adjustment it actually raises or lowers my model. I reloaded the file before printing but I wondered if this was normal?
BTW...i notice when I make the Z-axis scale adjustment it actually raises or lowers my model. I reloaded the file before printing but I wondered if this was normal?