Reify3D Forum

Hey!

I tried contacting Reify through the contact page on the website but haven't heard back in 2 weeks, so I figured posting here may be quicker.

I hadn't run my printer in a few months and recently went back to test out a few prints. I updated the laptop I use to run the printer, tried to open Contour, and was presented with a notification that it is no longer activated. I searched my email for the activation key but couldn't find it.

Hopefully someone who can help sees this post so I can get the printer running again.

Thanks!
-David

You need to contact your reseller. In your case it’s Junction 3d. Send me an email with your new product id and I’ll activate it. Info@junction3d.com