HELLO Everyone! I have hard time with printer!
I reinstall my pc for Windows 8.1 because I was running on 10. And I set up everything .
When I do $h operation load project to cw sliced pressing start arm does not wanna start. Projector lithing up and Cw time runs.
Other thing I have to pull out printer from usb each time when I close Cw? Because I can't connect printer.
Before reseting I don't have this problem.
Please help
Cw problems and ports
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Cw problems and ports
Pawel,
I will call you today and help you setup your PC again.
I will call you today and help you setup your PC again.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 7 guests