CW platform size

kghjewelry
Novice
Posts:27
Joined:Mon Apr 25, 2016 10:29 pm
CW platform size

Postby kghjewelry » Mon Jun 06, 2016 2:10 pm

Can CW platform work area be enlarged? My current area is about 20 X 30 mm.
Wdshea
Solus Expert
Posts:127
Joined:Wed Nov 25, 2015 5:49 am

Re: CW platform size

Postby Wdshea » Mon Jun 06, 2016 5:22 pm

yes, i am currently printing at 30u XY. i am using the 10x, and my build area is 58x by 32y. you will have to adjust zoom, and calibrate based on something of a known size. i use a 25mm cube.
haipham
Novice
Posts:66
Joined:Fri Jan 01, 2016 1:39 pm

Re: CW platform size

Postby haipham » Sun Jun 19, 2016 9:42 am

Wdshea wrote:yes, i am currently printing at 30u XY. i am using the 10x, and my build area is 58x by 32y. you will have to adjust zoom, and calibrate based on something of a known size. i use a 25mm cube.

how is your minimum prong size with this
Wdshea
Solus Expert
Posts:127
Joined:Wed Nov 25, 2015 5:49 am

Re: CW platform size

Postby Wdshea » Sun Jun 19, 2016 8:12 pm

none of what i print has prongs, we're not doing gems yet. positive details are much easier than negative, but i'd be willing to bet you can print any prong size.
haipham
Novice
Posts:66
Joined:Fri Jan 01, 2016 1:39 pm

Re: CW platform size

Postby haipham » Mon Jun 20, 2016 3:25 am

Wdshea wrote:none of what i print has prongs, we're not doing gems yet. positive details are much easier than negative, but i'd be willing to bet you can print any prong size.

ah, my question is about minimum support size, i had test, 0.35 is ok with 55x31 size. Very good
Wdshea
Solus Expert
Posts:127
Joined:Wed Nov 25, 2015 5:49 am

Re: CW platform size

Postby Wdshea » Mon Jun 20, 2016 4:59 am

i print supports down to .3, but they are intermediate (the base is connected to the part itself) and they are also short. when i print supports like that, i also make them cylinder all the way, and straight. i use b9 software.

Who is online

Users browsing this forum: No registered users and 16 guests