CW is not creating slice images??

[castawax]

Hello all, I tried to print a couple of models over the weekend, but I ran into a problem.

I started a run, and the sliced images initially came up blue instead of white. I thought that was odd, so I started printing anyway. It started printing the supports, but not the part. Figured the stl was bad.

Started again...
I did everything the way I've always done it-
Loaded the file
Added supports
Sliced the file
Hit the play button

Well, I noticed before I hit play, it said it created 600 some odd slices, but no images. Thought nothing of it. The build platform went down, then up, then down again... But the lamp was not turning on.

Tried it again. Same thing... Said it created slices, but no images. I can't seem to figure it out and I don't know what to do.

I know the lamp on the projector is working cause I'm able to see the faint light that is always there. And I can display the grid.

Anyone have this problem before? Please help!

[mongerdesigns]

Hi Manuel,

Contact me at info@junction3d.com and I can connect remotely to your pc and see what the issue is.

[reify]

Please check your foreground is set to white in the File->Preferences menu.

[castawax]

Thank you reify!! That seemed to have worked. I'll know for sure in a couple of hours. But it seems like I have to do that each time the laptop is turned on.

Minor inconvenience though - as long as I can print.

Thanks again!

[reify]

Try erasing CW and unzipping it again.