Hello all;
I am starting a new build and a few failures, and as I am sitting here watching the printer, the first 7 or so exposures are about 18 seconds long, then they drop off to about 3.5 seconds. Does this sound correct, my other printers both expose from about 18 to 45 seconds per layer?
How to I determine it this is the failure issue, and how do I adjust, and what did I do to have this build sequence?
Toddmichael
Exposure times during build
- toddmichael
- Novice
- Posts:77
- Joined:Sun Jul 05, 2015 4:33 am
- Location:Motor City, Mi
Toddmichael
Firestorm Cad / Jeweler / Designer
Firestorm Cad / Jeweler / Designer
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Exposure times during build
That is correct. 18s for the 3 base layers then 2.6s for subsequent layers after that.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 5 guests